|
Bio-Fighter
UVC Smokemaster
LakeAir MiracleAir
Central
Air Purifiers HEPA
PPA
UV Air Purifiers
Industrial Ozone
HVAC HEPA
Ducted HEPA
Germicidal UVC Air
Sponge EnviroCON Bio
Breeze
HVAC HEPA & UV
Air Purifiers
In Duct Partial Bypass Multi Filtration Systems
CAP600 Model, CAP600-UVP,
Model CAP 1200-UVP
|

Abatement Technologies |
Recommended by
Healthcare Professionals
The CAP
Systems, (Central Air Purifiers) feature true HEPA (High Efficiency
Particulate Air) filtration, designed to capture at least 99.97% of
contaminants at 0.3 microns in size. These state-of-the-art systems are
specifically designed to provide optimum performance against microscopic
airborne pathogens, allergens, irritants, and odors. They are often
recommended by allergists, pediatricians, and other health professionals to
provide their patients with the very best in home air purification. Several
models are available, the CAP600, CAP600-UVP and the CAP1200-UVP.
|
Standard
CAP600 Model
This model is equipped with three stages of
filtration. The first stage is a furnace-type throwaway filter
designed to capture coarse particulates and to extend the life of
the subsequent filters. The second stage is a dual-purpose pleated
filter, with a layer of particulate media for capturing finer
visible particles, and a layer of carbon media for removing gases,
VOCs, and odors. An optional heavy-duty granular carbon filter is
also available for homes with more severe VOC or odor problems from
smokers, pets, or cooking. The final stage HEPA (High Efficiency
Particulate Air) filter is tested and certified to be at least
99.97% efficient for capturing particles as small as 0.3 microns in
size, such as bacteria, mold and fungal spores, pollens, and
lung-damaging particles. |

|
-
In the partial bypass configuration, a portion of the air in the HVAC return
is pulled into the unit and purified on each pass through the system. This
enables CAP600 models to provide 50 to 60 clean air changes per day in an 1800
square foot home.
-
Dirty air is pulled through a 1" deep throw-away prefilter that removes
large, visible, particulate matter, and extends the life of subsequent
filters. Typical filter life is 3 months.
-
The
pleated 2" deep second stage filter removes most remaining visible
particles. A second layer of carbon media absorbs moderate gases and
odors. A special high capacity granular carbon filter is available for
homes with heavier odor problems.
-
The
powerful backward-curved motorized impeller provides more than double the
peak static capacity or forward curved squirrel cage blowers. This enables
CAP600 models to significantly increase the amount of air filtered,
especially as filters load, and increases filter life.
-
The
highly efficient motorized impeller consumes only 150 watts of energy,
which can save homeowners hundreds of dollars annually in electrical
consumption compared to insufficient squirrel cage blowers.
-
The
UV Plus lamp (CAP600-UVP model) combines UVGI and Photolysis technologies
to destroy bacteria, viruses, molds, and fungi, and break down VOCs and
odors.
-
The
UL Class II HEPA filter is designed to remove 99.97% of microscopic
impurities from the air, including organisms killed by the lamp, to ensure
that highly purified air is exhausted back into the HVAC system.
|
CAP600-UVP
Model
This "best of the best" model
provides homeowners with the ultimate in central air purification.
The CAP600-UVP offers all of the features of the standard CAP600
model, combined with the added benefits of our UV Plus (UVGI +
ozone) technology. The UV Plus lamp is installed on the inlet side
of the HEPA filter to continuously irradiate passing contaminants
and kill biological contaminants trapped on the HEPA media. A safety
interlock switch and other design features prevent any possibility
of direct exposure to UVGI radiation. An ozone-free model
(CAP600-UV) is also available. |

|
Recommended by
Healthcare Professionals
The CAP600 series features true HEPA (High Efficiency
Particulate Air) filtration, designed to capture at least 99.97% of
contaminants at 0.3 microns in size. These state-of-the-art systems are
specifically designed to provide optimum performance against microscopic
airborne pathogens, allergens, irritants, and odors. They are often
recommended by allergists, pediatricians, and other health professionals to
provide their patients with the very best in home air purification. Two
models are available, the CAP600 and the CAP600-UVP.
Self-Powered
CAP600 models are equipped with a powerful and
efficient motorized impeller to pull air through the filters, and designed
for installation into the HVAC system in a "partial bypass"
configuration, (See Diagram Below). This installation enables the CAP600 unit to pull a
significant portion of the air (typically about 50%) out of the HVAC return
and cleanse it through a series of filters, without adding any static load
to the HVAC motor/blower. The air exhausted back into the HVAC system is
cleaner than that in most hospital operating suites. CAP600 models can
provide approximately 60 clean air changes per day in an 1800 square foot
home.
Partial
Bypass Installation
The bypass
connections are made by cutting a 10-inch diameter hole into the return
duct, and connecting the inlet of the CAP600 model to the return duct with
10-inch rigid or flexible ducting. The exhaust of the CAP600 is similarly
connected back into the return duct or furnace plenum downstream from the
inlet connection to complete the "bypass loop". Continuous operation of the
HVAC fan and the CAP600 unit is recommended for maximum air cleaning
performance.

The CAP1200-UVP models
CAP1200-UVP are
equipped with a larger internal blower system designed to handle the
filtration requirements of HVAC systems that are four tons (1,600 cfm) or
larger. The CAP1200 Purifiers are capable of filtering all the air in a 4500
square foot home in 30 minutes!
These models have four
stages of filtration to handle the higher dirt-loading requirements of
larger systems: a 1"-deep Fiber-Trapper filter, a 2" pleated particulate
filter, a 2" heavy-duty Vapor-Lock carbon filter, and a 99.97% HEPA filter.
The CAP1200-UV model is
equipped features a UV-C Plus ozone/photolysis lamp.
Self-Powered
The
CAP1200 series models are equipped with a powerful, internal motor and
blower developed in Germany designed to pull air through dense filters.
These units are designed for installation into the cold-air return side of
the HVAC system, in a "partial bypass" configuration, (See Diagram Below).
Typical installations are designed to cleanse approximately 50% of the
return air during each pass through the system, without adding any load to
the HVAC motor/blower, and to provide 50 to 60 clean air changes per day in
the home.
Partial Bypass Installation
Bypass connections are made by cutting a
10-inch diameter hole into the return duct, and by connecting the inlet of
the CAP unit to the duct with 10-inch rigid or flexible ducting. The exhaust
of the CAP unit is similarly connected into the return duct or plenum
downstream from the inlet connection, to complete the "bypass loop".
Continuous operation of the HVAC fan and the CAP unit is recommended for
maximum "24/7" air cleaning performance and a healthier lifestyle.

Replacement Annual Filter Kits Available
Annual Filter Kit for the
CAP600 / CAP600-UVP:
-
PAK600: One year's supply of filters for CAP600 consists of:
1 cs. F621-12 (12 Prefilters): and 2 ea. VL602
-
PAK600-UV: One year's supply of filters and lamp for CAP600
consists of: 1 cs. F621-12 (12 Prefilters): and 2 ea. VL602; and 1 ea. UV625
12" UV-C Lamp
Annual Filter Kit for the
CAP1200-UVP:
Other Filter Kits and filter options available: HEPA Filters,
prefilters, 2nd and 3rd stage filters, UV, and UVP Lamps
Call or Contact US
for Price

The most highly
regarded mechanical filter is the HEPA (High Efficiency Particulate Air) or
absolute filter"… "HEPA or absolute filters are used in a large number of
medical, military, electronic and industrial applications where clean air,
even super-clean air, is essential to work."
- FDA Consumer Magazine


CAP600
Series Comparison Chart

CAP1200-UVP models available for 4-10 ton systems.

CAP600 &
CAP1200 Series & Specifications
| Specifications |
CAP600
&
CAP600-UVP |
CAP1200-UVP |
| Blower
Rating |
600
CFM |
1,080
CFM |
| AC
System Sizing |
1
- 5 ton systems |
4
- 10 ton systems |
| Dimensions |
16
3/4" x 16 5/8" x 29 1/2" |
16
3/4" x 16 5/8" x 33 1/8" |
| Weight |
55 |
61 |
| UL507
Compliant |
Yes |
Yes |
| Collar
Size - Inlet/Outlet |
10"
/ 10" |
10"
/ 10" |
| Energy
Consumption |
161
Watts & 210 Watts |
400
Watts & 439 Watts |
| First
& Second Stage Filter Changeable Without Tools |
Yes |
Yes |
| Metal
Frame 99.97% @ 0.3 Micron HEPA Filter |
Yes,
UL 900 Class 1 |
Yes,
UL 900 Class 1 |
| Filter
Change Indicator Lamp |
Yes |
Yes |
CAP
600 & CAP1200 Systems come with a 2 year warranty on materials and
workmanship,
excluding filters and UV bulbs. 1 year warranty on electrical components.
Call or Contact US for
Price Quote.
Other UV Light
Air Purification Air Purification Products
Air
Oasis Advanced Hydrated Photocatalytic Oxidation UV
Biozone
UV Light Room Air Purifiers
|